Astm a860

The product analysis shall be the basis for rejection. The nickel content of the deposited weld metal shall not exceed 1. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.

Uploader: Narr
Date Added: 2 November 2006
File Size: 57.44 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 94075
Price: Free* [*Free Regsitration Required]





These fittings are for use in high — pressure gas and oil transmission and distribution system. A chemical analysis shall be performed on deposited weld metal for. In pallets, in plywood cases, in bulk. Internal and external surface shall be examined when size permits permits accessibility. Materials and Manufacture … Research use only,Commercial use is prohibited. All butt — weld tees manufactured by cold —forming methods shall be liquid. These fittings are asm use in high-pressure gas and oil transmission and distribution systems.

The material for fittings shall be xstm killed fine — grain material made by a.

And over, Sizes tested Section;min, specimen, thickness [7. Link to Active This link will always route to the current Active version of the standard. Rectangular For Less than [7. A chemical analysis shall be performed on deposited weld metal atm each heat of filler metal orfor submerged arc weldingeach heat of filler metal and batch of flux the weld metal shall be deposited in accordance with the qualified weld procedure.

Standard Specimen, Size Specimen. These fittings are for use in high-pressure gas and oil transmission and ashm systems.

JIS G Arc welded carbon steel pipes. Starting materials shall consist of plate, sheet, forgings, forging adtm bar, and seamless or fusion-welded tubular products with filler metal added.

Butt-welding fittings differing from these. One or more of the supplementary requirements may be specified in the order. One or more of the supplementary requirements may be specified in the order. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Combining values from the two systems may result in nonconformance with this specification.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. This specification does not require hydrostatic testing.

JIS G Carbon steel pipes for high temperature service. The product analysis shall be the basis for rejection.

Section V, Nondestructive Examination. Specimens shall conform to required values of chemical composition and mechanical properties, namely: After the removal of astk cracksthe tees shall be re.

Wrought austenitic and austenitic-ferritic duplex stainless steels without specific inspection requirements BS EN Butt-welding pipe fittings Part 4: Within the text, the SI units are shown in brackets.

And over, Sizes tested Section;min. JIS G Steel pipes for low temperature service.

JIS G Carbon steel pipes for pressure service. These fittings are for use in. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. This specification covers wrought high-strength low-alloy butt-welding steel fittings of seamless and electric fusion-welded construction for applications in high-pressure gas and oil transmission adtm distribution systems.

4 thoughts on “Astm a860”

Leave a Reply

Your email address will not be published. Required fields are marked *