Ansys designmodeler tutorials

In the Draw toolbox, select Arc by Center and click once on the origin center of the arc. This indicates that the cell requires data for example, a geometry. Note that the inches measurement appears automatically when you click outside of this box. As with the main pipe, a profile will be created, but with the side pipe, the Extrude operation will be used to create the body of the pipe.

Uploader: Bragore
Date Added: 15 January 2006
File Size: 19.93 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 73449
Price: Free* [*Free Regsitration Required]





Set up the plane: Selecting the plane first ensures that the new sketch is based on Plane4. Together, the arc and the two straight lines form a curving line that is the path through which the half-circle profile will be swept. Set the Path to Sketch2: If the wrong part of the arc is drawn and it does not resemble Figure 1.

The grid settings that you have just set up will help you to position the arc and set its radius correctly. Click once on the origin, then once some distance along the X axis in either a positive or a negative direction. Beam Modeling Workshop 5. Register for a subscription using the tab below or contact training ansys.

Lectures and computer practical sessions to validate acquired knowledge. Students who attend this course will learn how to:. Note that the inches measurement anshs automatically when you click outside of this box. Students who attend this course will learn how to: The question mark in the Geometry cell is replaced by a check mark, indicating that there is a geometry now associated with the fluid flow analysis system.

With the new plane selected in the Tree Outlineclick the New Sketch icon. Complete a class on your own schedule at your own pace. Scope is equivalent to Instructor led classes. You can do this by holding down the right mouse button and dragging a box over the desired viewing area.

At this stage, when you drag the unclicked mouse, DesignModeler will create an arc with a fixed radius. Draw a ansjs connecting the open ends of the arc.

Introduction to ANSYS DesignModeler | ANSYS

Geometry Cleanup Workshop 3. In the Draw toolbox, select Arc by Center and click once on the origin center of tutorils arc. Core Skills Workshop 1. Includes video lecture, workshops and input files. Dragging side to side rotates the view about the vertical axis, and dragging up and down rotates the view about the horizontal axis.

Sorry, no classes were found that matched your country selection. On the Sketching tab, open the Draw toolbox and select Arc by Center.

Introduction to ANSYS DesignModeler - (Also available as Self-paced Learning)

The following table describes mouse actions that are available:. You can also right-click the Geometry cell to display the context menu, then select New Geometry As before, first make the ZXPlane active by clicking on it, then click the New Plane icon to anssy the plane based upon it. As with the main pipe, a profile will be created, but with the side pipe, the Extrude operation will be used to create the body of the pipe.

Geometry Creation and Modeling Workshop 2. With the mouse button unclicked, draw an arc to the opposite side of the origin and click the X axis again. This closed half-circle will be used as the profile for the extrude operation. This closed half-circle will be used designmldeler the profile during the sweep. For the purposes of this tutorial where you will create the geometry in inches and perform the CFD analysis using SI unitsselect Inch as the desired length unit and click OK to close the prompt.

4 thoughts on “Ansys designmodeler tutorials”

  1. It is a pity, that now I can not express - I hurry up on job. I will be released - I will necessarily express the opinion.

Leave a Reply

Your email address will not be published. Required fields are marked *