Rewinding electric motors

No other type will be able to channel the electromagnetic energy needed to turn the motor. How Does an Electric Motor Work? Priest Electric is a reliable service provider trained in electric motor rewinding in Boise, Idaho, Nevada, and Oregon. When it receives the magnetic force of the stator and windings, it spins, powering the motor. But how can I be sure of the direction per my connection?

Uploader: Nigore
Date Added: 22 December 2012
File Size: 58.84 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 83262
Price: Free* [*Free Regsitration Required]





Motor Rewinding Procedures

Doing so will complete the circuit, allowing energy to flow from the generator through the windings to the armature. Here are jotors specs: It should be completely clean before you crack open the motor. Add a photo Upload error.

Alternating current AC and direct current DC motors employ an insulated, current-carrying coil essential to their operation. On the other hand, those times when a motor has failed are also opportunities to upgrade motor efficiency. Place one of the probes on one of the copper commutation pads and the other on any part of the steel laminations of the armature.

Motors fail for various reasons.

JH Jose Huerta Sep 3, The coils must be insulated at all times. Also the amount of wire to be exact when winding it back to the stator really is important, that's why I had measured it after I removed it, thanks for the heads up.

The original bearings will be replaced with new bearings of the same type. Twist the two wires tightly around the edge of the tab.

How to Rewind an Electric Motor: 14 Steps (with Pictures)

They have a full service shop for electric motor repairand can also provide on-site service. Not Helpful 16 Helpful Otherwise, it may be a rewindding fit or cause conductivity issues. Having a motor rewound often takes less than 24 hours. Tips If possible, practice on an old or inexpensive motor before you attempt to rewind an expensive one.

Tell us more about it?

Pull the cut coils free of the armature or stator by hand. When the decision to rewind a motor the motor housing is first removed to expose the windings.

This procedure is known as dip and bake. How will a motor perform if a wire of a higher gauge than the original is used? If efficiency must be maintained because operating cost is high, and if the stator needs to be heated in order to be stripped, ask your rewinder to have the burnout done using thermostatically-controlled equipment.

If the coils rewindiing to budge, it's possible that they haven't been severed completely. It also contains some handy appendices, including the Lincoln Motors Troubleshooting Chartsa Motor Purchase Specification FormElectric Motor Repair Specificationsand forms for use by motor repair shops to keep records on the motors they repair.

Unless you are experienced, having a professional perform the task will save you money and headache in the long run.

Professional Electric Motor Rewinding

DY Dereje Yitayew Jul 22, Acquiring a new replacement motor is likely to take longer. The exact winding pattern is recreated and number of coils around each winding.

Your motor may not work correctly motogs you make a mistake. In some motors the windings are held in place with varnish or epoxy resin. Especially if the failed motor is 10 or more years old — perhaps with unknown efficiency, and possibly having been improperly rewound in the past — you will want to seriously consider all the options, and look motprs the economics of replacing it with a new EE motor.

If one of them happens to break off, you may have trouble keeping the replacement windings in place later on. Made Recently View more 16 total.

5 thoughts on “Rewinding electric motors”

  1. I can not participate now in discussion - there is no free time. I will be released - I will necessarily express the opinion on this question.

Leave a Reply

Your email address will not be published. Required fields are marked *