Astm a354

No other units of measurement are included in this standard. Users should note that A and A are not exact equivalents to the structural grades in this specification. Hardness, tensile strength, yield strength, elongation, and area reduction shall be tested to meet the requirements prescribed.

Uploader: Zuk
Date Added: 12 April 2015
File Size: 29.82 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 10972
Price: Free* [*Free Regsitration Required]





This abstract is a brief summary of the referenced standard. Selection will depend upon design and the stresses and service for which the product is to be used.

ASTM A - Portland Bolt

This indicates that A Grade BD can be an alternative for Grade A bolts if the requirement is for something other than heavy hex bolts with standard structural bolt thread lengths the mention of A is related to F Grade A ASTM A is a fastener specification covering alloy x354 stainless steel bolts and threaded studs for use with flanges, valves, pressure vessels, and fittings for high temperature and high pressure service.

Asmt of Fastener and Surface Finish. Nut Grade and Style A. No other units of measurement are included in this standard.

ASTM A - ASTM A

AB7 fully threaded studs and heavy hex bolts are widely available in the marketplace. Heads of ABC bolts will be standard hex, while AB7 will be heavy hex unless otherwise specified. Hardness, tensile strength, yield strength, elongation, and area reduction shall be tested to meet the requirements prescribed.

Users should note that A and A are not exact equivalents to the structural grades in this specification. There are some differences beyond just the intended application though. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

A is defined as fasteners for application at normal atmospheric temperatures, where high strength awtm required and for limited application at elevated temperature.

Link to Active This link will always route to the current Active version of the standard. Any alloy steel capable of meeting the mechanical and chemical properties set forth in this specification may be used.

Unless otherwise specified, the grade and style of nut for each grade of fastener shall be as follows: Bolts manufactured under this specification are intended for use in structural connections. Historical Version s - asrm previous versions of standard.

A354 Bolts

The intended application for F is as an anchor bolt, and F Grade covers a slightly narrower range of diameters than A This specification covers the chemical and mechanical requirements of quenched and tempered alloy steel bolts, studs, and other externally threaded fasteners.

F Grade is the highest strength of the three grades within the F specification, which covers steel anchor bolts intended for anchoring structural supports to concrete foundations.

Unless otherwise specified, the grade and style of nut for each grade of fastener shall be as follows:. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

Also note that F Grade has a maximum tensile strength of ksi, while A a34 no maximum. All fasteners shall be made from alloy steel conforming to the chemical composition requirements. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.

5 thoughts on “Astm a354”

  1. In it something is. It is grateful to you for the help in this question. I did not know it.

Leave a Reply

Your email address will not be published. Required fields are marked *