Canon ir3300 error codes list

Action Each PCI slot may be disabled in service mode to prevent the error: Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US. Replace the scanning lamp. When the fixing motor is rotating, is the film rotation detection signal sent by the fixing film sensor to the concoctor J of the DC controller PCB?

Uploader: Kajizil
Date Added: 4 December 2006
File Size: 61.6 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 53843
Price: Free* [*Free Regsitration Required]





Main cause The PCI bus has poor connection.

Canon IR Error Code List - Copy Care Enterprise

E The stapler unit does not leave home position when the stapler slide motor is driven for 4. If the fixing film is normal, replace the frror.

E The communication with the DA unit is not resumed 3 sec or more after it is disrupted. Main cause The main controller PCB is faulty. The horizontal registration motor is faulty.

The machine controller PCB is faulty. Or you may need a new fuser unit. Replace the main power supply PCB. Check the available memory of the main unit, and delete unwanted doc.

Canon iR 3300 Reference Manual: List Of Error Codes Without Messages

The thermistor control mechanism is faulty. Hi there, Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two. The main power supply PCB is faulty. The fixing film unit is faulty i. E While an original is being read, the image leading edge signal does not arrive from the ADF.

Page of Go. Cause The stapler motor M6 is faulty. E A fault is detected in the battery for the image memory. Foreign matter Is there foreign matter that prevents the rotation of the fan? Is the drive voltage of codse heater supplied by the connector J8 of the main power supply PCB?

The heater drive power supply is faulty. The aligning plate home position sensor S6 does not go OFF when the front alignment motor M3 is driven for a specific number of rotations. The main thermistor or the lis thermistor detects overheating hardware circuit detection Causes: The image processing element of the ir33300 controller PCB lisg a fault.

E The paddle does not leave home position when the paddle motor is driven for 2 sec or more. E A fault is detected in the image memory. System software Try re-installing the system software.

Check to see if the main power switch is ON, and try again if necessary. The delivery tray paper height sensor S10 is faulty, the harness is disconnected, or an open circuit exits. E The communication between the copier and the finisher is disrupted and is not corrected for 5 sec or less.

Canon IR 3300 Error Code List

Main cause The waste toner case is full. The code may be checked in service mode: Replace the reader controller PCB. Is the proem corrected?

The wiring is faulty short circuit, open circuit.

Clean the contact, and set it once again. The stapling home position sensor S16 dos not go ON with 0.

2 thoughts on “Canon ir3300 error codes list”

Leave a Reply

Your email address will not be published. Required fields are marked *